Zinс-Boron

Complex microfertilizer

Composition, g/l: Technical indicators: Density, g/l: Chelating Agent:
Zn - 65рН 8,4-8,91250-1300citric acid-monoethanolamine
В - 50
N - 52

The water-soluble concentrate fertilizer, containing zinc in chelate form and boron in the form of complex organic polyborates. It is used for crops receptive to deficiency of zinc and boron during the active vegetation period. The original combination of these elements has a positive effect on the formation of the reproductive organs of the plant.

It is used for crops sensitive to deficiency of zinc and boron during the active vegetation period. The original combination of these elements has a positive effect on the formation of the reproductive organs of the plant.

RECOMMENDATIONS FOR USE

Fertilizer is used as a working solution (from 200 liters to 400 liters per 1 hectare) alone or with the with adding of mineral fertilizer (urea - 2-6 kg / ha or ammonium sulfate - 2-5 kg / ha or magnesium sulphate - 4-8 kg / ha). It is possible to use fertilizer for the preparation of complex mixtures with plant protection products, in case if a positive result is obtained in the compatibility test.

Vegetating plants treatment

The treatment is carried out with a dose of 1,0-1,5 l / ha (200-400 l of working solution per 1 ha) in the following phases of development of plants:

1. Rapeseed, mustard - 2-4 leaves phase, stemming, budding

2. Sunflower - 2-3 pairs of leaves phase, 4-6 pairs of leaves phase, budding

3. Linen oilseed – 5-6 pairs of leaves phase - flowering, budding

4. Legumes – 3-5 leaves, budding, forming beans

5. Cereals – 2-4 leaves – tillering, stem extension — beginning of heading, milk development in kernel

- Fertilization is carried out in the mornings, and not allowed to carry it out in sunny hours. In cloudy weather treatment can be carried out at any time, but not later than 5 hours before sunset. Not allowed to make the treatment in rainy weather and while strong wind.

- It is recommended the plants to be treated at an air temperature of at least + 18 °C and not higher than 25 °C. In this temperature range, the maximum efficiency of applied fertilizers is observed, what is reached due to the optimal absorption rate of nutrient components by the leaf surface.

- To prepare working solutions water with a temperature of 15-22 °C is used. Water with a temperature below 8°C adversely affects the supply of nutrient components to the plant and can cause a stressful condition due to sharp temperature drop.


For more details call our managers

Tel: +38 (057) 766-09-41

or leave the application e-mail: sales@kharkov-himprom.com